Screw installation

1. If your mount has hidden screw holes, open them up by gently applying pressure inward from the front and back of the holes with a screw driver. You should not need to remove any plastic.
2. Hold the mount up on the wall where you would like it to be placed.
3. Mark the hole(s) on the wall and remove the mount from the wall
4. If using the drywall anchors:
   
   1. Make an indent where the anchor will be placed. I use the tip of my Phillips driver.
   2. Using a screw driver, slowly screw in the anchor into the wall with light pressure until the head of the anchors are touching the wall and you feel additional resistance. Over tightening the anchor may strip it from the wall.
   3. Repeat for each anchor needed for the mount.
5. Hold the mount up to the wall and install the screws with a screw driver until snug. Over tightening may damage the mount, anchor or wall.
6. Repeat for each screw needed. 
7. Gently test the installation by cautiously placing the intended car on the mount.

If you have any questions or still need assistance, please contact us!